Installing And Configuring An Ethernet Connection; Step 1: Connect To The Ultrakey Plus Ethernet Port; Table 2-2 Rj45 Ethernet Pin Assignments - Honeywell HJK7000 Installation And User Manual

Installing and Configuring an Ethernet Connection

Step 1: Connect to the UltraKey Plus Ethernet Port

Document 800-02573 Rev B
11/2009
For a list of accessories see
pin assignments see UltraKey Plus Port Connections and Descriptions
UltraKey Plus Controller runs TCP/IP keyboard protocol.
Note The direct RJ45 connection using the Ethernet port is only available with
newer model VideoBloX NetCPU systems.
Table 2-2 RJ45 Ethernet Pin Assignments
Port Pin
RJ45 Ethernet 1
2
3
6
To connect to the UltraKey Plus Ethernet port:
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See Figure
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Plug an RJ45 network cable from the network to the controller Ethernet port. Up to 32
controllers can be connected to the network. See
4. Connect VideoBloX to the network. Refer to the applicable
Guide for instructions.
UltraKey Plus Controller Installation and User Guide
Shipping Checklist on page
Signal
TX +
TX -
RX+
RX-
2-2.
18 and for port connections and
on page 19. The
Figure 2-6.
VideoBloX Installation
35