ID
Here is for you to input front device ID.
Move the cursor to highlight ID and then use input numeral.
If there is a * before the ID number (such as *3), it means that front device has control point
setup.
You can view device *3 corresponding type and name.
Device Name
Here is for you to input device name. You can use various input methods to give a name to
the front device,
Device Type
There are several options: DVR/dome/matrix/NVS. You can use left/right key to select.
Connection Type
There are several options: network/RS232/RS485. You can use left/right key to select
corresponding connection type.
After you have selected connection type, please click ENTER to go on connection setup.
Network
When connection type is network, click ENTER key you can see an interface ask you to input
the following information
IP
Port
Protocol
IP: 000.000.000.000
Port::00000
Protocol: DH--1
Honeywell
15