Installing UltraKey Plus with VideoBloX
Step 3: Configure Address
Step 4: Configure the Controller for VideoBloX Mode
34
Note
The default baud rate for VideoBloX is 19200 bps. It is recommended that you
do not change this setting.
9.
Press DataBit to select 7 bit or 8 bit.
10. Press parity to select Even, Odd or None.
11. Press Stop Bit to select 1 bit or 2 bit.
12. Press Save, and then Quit.
13. If you are using the TCP/IP to connect to a VideoBloX NetCPU, press Ethernet.
Note
In this field, you are setting the VideoBloX Netcpu IP address. To set the
UltraKey Plus IP address, see
Connection, page 36.
To configure the controller address:
1.
Press Quit to exit from Port Settings menu.
2.
Press Keyboard Addr to select an address between 1 and 32 to assign to the
controller. You can also use the numeric keypad to enter a number between 1 and 32.
Entering a number greater than 32, makes this operation invalid.
3.
Press Enter to save the address and exit the configuration menu.
To configure the controller for VideoBloX mode:
1.
Press Users Menu to display the configuration screen.
2.
Refer to
User Menus
on page
3.
Press Home and then Quit to exit when the configuration is finished.
Step 2: Set and Configure for an Ethernet
62
to configure the device.