Step 3: Configure Address And Joystick Speed; Step 4: Configure The Controller For Maxpro Mode - Honeywell HJK7000 Installation And User Manual

Step 3: Configure Address and Joystick Speed

Step 4: Configure the Controller for MAXPRO Mode

Document 800-02573 Rev B
11/2009
4. If the current mode is VB mode, change it to MAXPRO mode by pressing the Mode
VB button and logging into the Setting menu again.
5. Press Hardware Config.
The current controller setting is displayed.
6. Press Port Settings and then Ethernet.
The Ethernet Settings are displayed.
7. Press IP Address and use the numeric keypad or LCD Touch Panel to enter an IP
address, as required.
8. Press Subnet Mask, and enter a NetMask as required. Press Enter.
9. Press Default Gateway. Using the number key or LCD Touch Panel to enter a
Gateway, as required. Press Enter.
10. Press Sys.Cntl.IP Address, using the number key or LCD Touch Panel to enter the
address of the device, as required. Press Enter.
11. Press Save to exit from the Ethernet Settings menu.
To configure the address and joystick speed:
Quit
1. Press to exit from the Port Settings menu.
Keyboard Address
2. Press
controller. You can also use the numeric keypad to enter a number between 1 and 99.
3. Press Enter to save the address and exit the configuration menu.
4. Press Joystick Res to select Low or High.
5. Press Save.
A message confirming the operation displays.
Press Yes to save or No to cancel.
To configure the controller for MAXPRO mode:
1. Press Users Menu to display the configuration screen.
2. See User Menus on page
3. Press Home and then Quit to exit when the configuration is finished.
Note Serial Port and Ethernet can not be used at the same time in MAXPRO mode.
UltraKey Plus Controller Installation and User Guide
to select an address between 1 and 99 to assign to the
62 to configure the device.
49