Step 3: Configure Address And Joystick Speed; Step 4: Configure The Controller For Maxpro Mode - Honeywell HJK7000 Installation And User Manual

Step 3: Configure Address and Joystick Speed

Step 4: Configure the Controller for MAXPRO Mode

Document 800-02573 Rev B
11/2009
6. Press Port Settings and then either COM1 or COM2.
The Serial Setting menu displays where you can see these settings - serial port mode,
baud rate, databit, parity and stop bit.
• Press Type to select RS422 or RS232.
• Press Baudrate to select a baud rate: 1200 bps, 1800, 2400, 4800, 9600, 19200
or 57600.
Note The default baud rate for most MAXPRO systems is 19200 bps.
• Press DataBit to select 7 bit or 8 bit.
• Press parity to select Even, Odd or None.
• Press Stop Bit to select 1 bit or 2 bits.
7. Press Save to quit the serial port settings.
8. Press Ethernet.
Then the Ethernet Settings are displayed.
9. Press IP Address and use the numeric keypad or LCD Touch Panel to enter an IP
address, as required.
10. Press Save to exit from the Ethernet Settings menu.
To configure the controller address and joystick speed:
1. Press Quit to exit from Port Settings menu.
2. Press Keyboard Addr to select an address between 1 and 99 to assign to the
controller. You can also use the numeric keypad to enter a number between 1 and 99.
3. Press Enter to save the address and exit the configuration menu.
4. Press Joystick Res to select Low or High.
5. Press Save.
A message displays confirming the operation.
Press Yes to save or No to cancel.
To configure the controller for MAXPRO mode:
1. Press Users Menu to display the configuration screen.
2. See User Menus on page
3. Press Home, and then Quit to exit when the configuration is finished.
UltraKey Plus Controller Installation and User Guide
62 to configure the device.
47