Table of Contents
Advertisement
Installing and Configuring a Serial Connection
Step 1: Connect to the UltraKey Plus Using the Serial Port
Document 800-02573 Rev B
11/2009
Note
Use only COM1 when in VideoBloX mode. See
Table 2-1
Serial Port COM1 and COM2 Pin Assignments
Serial Port
Type
COM1
RS422
RS485
Note
For a list of accessories see
For port connections see
page 19.
To connect to the UltraKey Plus using the serial port:
1.
Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See
Figure
2.
Plug the AC adapter into the controller power port and the adapter into a power
source.
3.
Connect an RJ45 network cable to the controller serial port.
4.
Connect the RJ45 network cable to VideoBloX:
•
For backwards compatibility with VideoBloX and VideoBloX Lite CPUs, an RJ45
to DB9 male adapter is required and included with your shipment. See
•
For VideoBloX NetCPU, the installation is a direct connection with the RJ45
network cable, also included. See
UltraKey Plus Controller Installation and User Guide
Pin
Signal
1
RX +
2
RX -
5
GND
7
TX -
8
TX +
7
T/R -
8
T/R +
Shipping Checklist
UltraKey Plus Port Connections and Descriptions
2-2.
Figure 2-4
Table 2-1
below.
on page 18.
Figure
and
Figure
2-5.
on
2-3.
31
Hide quick links:
Advertisement
Table of Contents
