System Problems - NEC POWERMATE ENTERPRISE - 09-1997 Manual

System Problems

Check the following list to match your problem and see the
possible cause and solution.
T
No power and power lamp not lit.
Check that all power switches are on.
Check that the power cable is plugged into the system
power socket. Check that the other end of the cable is
plugged into a live, properly grounded AC power outlet
or surge protector.
Check the outlet or surge protector by plugging in a
lamp.
T
Non-System Disk error message displays when the
system is started.
You have a diskette in the diskette drive, and the diskette
drive is set before the hard disk drive in boot order.
Remove the diskette from drive A and restart the system.
T
System does not boot and error message displayed
on screen.
Run the Setup Utility (see Chapter 4). Check that the
parameters are set correctly, particularly if you just
installed an option.
T
System emits continuous beeps.
Turn the system off, wait at least five seconds, and turn
the system on. If the beeps continue, call your NECCSD
dealer or the NECCSD Technical Support Center.
T
System does not maintain date, time, system
configuration information.
Change the battery (see "Replacing the Battery" in this
chapter). For assistance, call your NECCSD dealer or
the NECCSD Technical Support Center.
8-2 Solving System Problems