Slide the cover forward to meet the front panel.
3.
NOTE
The cover fits tightly. If the cover does not
slide all the way to the front panel, place one hand
on the front of the unit while you slide the cover
forward from the rear.
Secure the cover with the three thumb screws. (See
4.
"Removing the Minitower Cover," earlier in this
chapter.)
5.
Place the system unit over the stand with its front edge
about 1/2 inch from the front of the stand. Align the tabs
on the stand with the slots on the floor of the chassis.
!
To prevent tipping, always place the system unit
back in its stand after completing a system upgrade.
WARNING
Installing Options 5-13