Seagate Barracuda - NEC POWERMATE ENTERPRISE - 09-1997 Manual

T
CS: Cable Select jumper
T
Master device
T
Master device with Slave present (if the Slave drive does
not use the Drive Active/Slave Present (DASP-) signal
to indicate its presence:
T
Slave device

Seagate Barracuda

The Seagate Barracuda SCSI drive uses jumper blocks A3,
A2, A1, and A0 to configure the SCSI ID for the drive. See
the documentation that comes with the drive for more
information on when to configure the drive. The SCSI ID
jumpering is listed below.
T
SCSI ID=0, no jumpers
T
SCSI ID=1, A0 jumpered
T
SCSI ID=2, A1 jumpered
T
SCSI ID=3, A1 and A0 jumpered
T
SCSI ID=4, A2 jumpered
T
SCSI ID=5, A2 and A0 jumpered
T
SCSI ID=6, A2 and A1 jumpered
T
SCSI ID=7, A2, A1, and A0 jumpered
T
SCSI ID=8, A3 jumpered
Enabled, DS jumpered (factory default)
Disabled, DS open
Enabled, DS and CS jumpered
Disabled, CS open
Disabled, PK open (factory default)
Enabled, PK jumpered
Not used
Setting Jumpers 6-9