Assemble The Lower Bar And Carrier Beam - Cisco Room Kit EQX Installation Manual

1. Assemble the lower bar and carrier beam

Carrier beam and lower bar parts
(Box: A)
1x carrier beam (left)
1x carrier beam (right)
1x joining bracket for carrier beam
1x lower bar (center))
2x lower bar (sides)
16x 10x
(M6x12, Hex 4 mm) (M6x8, Hex 4 mm)
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
8x sliding nut
Before you start
When assembling the wall stand, quite often there a four
screws fixing two parts together. In those cases, we
recommend the following:
1. Enter, but not tighten, the screws in the order shown
here (zig-zag pattern).
2. Tighten the screws in the same order.
1 3
4 2
6
3
1
2
4
Copyright © 2024 Cisco Systems, Inc. All rights reserved.