Mount The Bottom Grille - Cisco Room Kit EQX Installation Manual

20. Mount the bottom grille

Both the speaker grille (assembled in step
grille (assembled in this step) consist of several parts. The
corners and stiffeners are equal for both grilles; the top/
bottom panels are different.
Bottom grille
(Box: D)
1x textile bottom grille
1x left corner 1x right corner
1x left stiffener 1x right stiffener
2x bottom panel
1x bottom panel
(left and right)
(center)
32x
(M4x10, Torx T20)
32x 4x
(M6x8, Hex 4 mm)
(Plastic washer)
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
20.1. Assemble the bottom grille
1. Place the textile bottom grille on a flat and clean surface,
front side down.
19) and bottom
×2
6x
6x
54
2. The pegs on the grille has threaded holes for screws.
The left and right corners are fastened to the rear of the
grille using three screws
(M4x10, Torx T20)
for each corner.
(Plastic washer)
a. Place the corner onto the pegs as shown in the
illustration.
b. Place the washers on the pegs.
c. Screw through the washers and into the pegs.
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
and washers