Honeywell BENDIX/KING KAP 140 Maintenance Manual page 73

3.4.2 INSTALLATION OFFSETS
Pressing '2' followed by 'ENTER' when the Installation Menu screen is displayed will cause the
Installation Offsets screen to be displayed, as shown in Figure 3--17. Pressing the 'ENTER' key
at this point will return the user to the Installation Menu screen.
This screen lists sensor inputs to the FCC whose offsets can be compensated for by software in
order to optimize system performance. These adjustments are stored in the configuration module
and may be repeated without performing installation setup again.
When a sensor input is selected, as shown in Figure 3--18, the FCC prompts the user to press the
'ENTER' key when the sensor NULL position is reached. The installer should make sure the
sensor input is nulled before proceeding. When the 'ENTER' key is pressed, the analog value is
read by the FCC and stored in the configuration module and used to compensate the sensor when
the autopilot is engaged.
Press CR when NULL position is reached for Glideslope Deviation
Revision 2, Dec/2002
CS:15574F02
BENDIX/KING
System mode: Normal
SET INSTALLATION OFFSETS
------------------------
1 - Glideslope Deviation
2 - Localizer Deviation
3 - VOR Deviation
4 - GPS Deviation
5 - Heading Datum
6 - Course Datum
Press key for desired option (<CR> to exit)
FIGURE 3--17 INSTALLATION OFFSETS SCREEN
System mode: Normal
SET INSTALLATION OFFSETS
------------------------
1 - Glideslope Deviation
2 - Localizer Deviation
3 - VOR Deviation
4 - GPS Deviation
5 - Heading Datum
6 - Course Datum
FIGURE 3--18 GLIDESLOPE DEVIATION SCREEN
KAP 140
Page 3--29