Honeywell BENDIX/KING KAP 140 Maintenance Manual page 17

1.3 PRODUCT SUPPORT
When a component of the KAP 140 Flight Control system exhibits a failure, it must be repaired by
an Honeywell Approved Sales and Service Center with an Honeywell service category rating of
5H. These Approved Sales and Service Centers have maintenance manuals, test sets, tools and
trained personnel approved by Honeywell to perform troubleshooting and repair on the equipment
on which they are rated. Maintenance and troubleshooting information that would normally be
available at these Approved Sales and Service Centers is not duplicated in this document. A list
of Honeywell Approved Sales and Service Centers can be obtained from Honeywell Product
Services, (USA) 913--782--0600.
1.4 AIRWORTHINESS LIMITATIONS
The FCCs with mod 2 are limited to a total of 300 hours of service before they must be returned
to the factory for testing. FCCs with mod 3 (which have been factory tested) are limited to 800 hours
between factory tests. --2xxx, --xxx2, --xxx3, --xxx4 as well as --5101 and --5201 FCCs with mod
4 (01/06 SW) have no required service limitations. Servo slip clutches need to be checked every
1000 hours or as specified in the STC maintenance manual.
Revision 2, Dec/2002
CS:15574F02.IDU
BENDIX/KING
KAP 140
Page 1--7