Add The Phone To A Nonbroadcast Wi-Fi Network - Cisco 840 User Manual

Add the phone to a nonbroadcast Wi-Fi network

Add the phone to a nonbroadcast Wi-Fi network
Follow these steps to add your phone to a Wi-Fi network that is hidden or not broadcast.
Before you begin
Get the following information about the Wi-Fi network from your administrator:
• Network name or Service Set Identifier (SSID)
• Network security mode:
• PIN or passkey for the security mode, if you use one
Check with your administrator to see if you need any certificates and arrange to install the certificates on your
phone.
Procedure
Step 1 Swipe up from the bottom of the phone's display to show the installed applications.
Step 2
Tap the Settings
Step 3 Select Network & internet > Wi-Fi.
Step 4
Tap Add Network.
Step 5 Enter the desired Wi-Fi Network name.
Step 6
Select the desired Security:
• For an open network, select None.
• For a PSK enabled Wi-Fi network, select WPA2- Personal and enter the 8-63 ASCII or 64 HEX
• For an EAP enabled Wi-Fi network, select WPA2-Enterprise.
Step 7 For a WPA2-Enterprise network, select the EAP method: PEAP, TLS, or TTLS.
Step 8
For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.
Step 9 For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and
CA certificate option to use, and then enter the Identity and Password.
Step 10 Under Advanced options, set Hidden network to Yes.
You can also set the Proxy and IP settings as required.
Cisco Wireless Phone 840 and 860 User Guide
48
• None
• Wi-Fi Protected Access II (WPA2)-Personal: Pre-shared key (PSK)
• WPA2-Enterprise with EAP method:
• Protected Extensible Authentication Protocol (PEAP)
• Extensible Authentication Protocol (EAP) Transport Layer Security (EAP-TLS)
• EAP Tunneled Transport Layer Security (EAP-TTLS)
app.
Password.
Phone setup