Add The Phone To A Broadcasted Wi-Fi Network - Cisco 840 User Manual

Phone setup
• Broadcasted
• Nonbroadcast or hidden

Add the phone to a broadcasted Wi-Fi network

You add the phone to a broadcasted Wi-Fi network through the startup wizard, or offline through the Settings
app.
Before you begin
Get the following information about the Wi-Fi network from your administrator:
• Network name or Service Set Identifier (SSID)
• Network security mode:
• PIN or passkey for the security mode, if you use one
Check with your administrator to see if you need any certificates and arrange to install the certificates on your
phone.
Procedure
Step 1 Swipe up from the bottom of the phone's display to show the installed applications.
Step 2
Tap the Settings
Step 3 Select Network & internet > Wi-Fi.
Step 4 Tap the desired Wi-Fi network name.
If the network doesn't have a security mode, the phone automatically connects to the Wi-Fi network.
If the network security mode is PSK, enter the 8–63 ASCII or 64 Hex Passphrase.
Step 5
For a network with a PEAP, EAP-TLS, or EAP-TTLS security mode, select the EAP method: PEAP, TLS,
or TTLS.
Step 6
For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.
Step 7 For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and
CA certificate option to use, and then enter the Identity and Password.
Step 8 Tap Connect.
• None
• Pre-shared key (PSK)
• Protected Extensible Authentication Protocol (PEAP)
• Extensible Authentication Protocol (EAP) Transport Layer Security (EAP-TLS)
• EAP Tunneled Transport Layer Security (EAP-TTLS)
app.
Add the phone to a broadcasted Wi-Fi network
Cisco Wireless Phone 840 and 860 User Guide
47