Standard Base For Cisco Headset 561 And 562; Cisco Headset 561 And 562 With Multibase - Cisco 7800 Series User Manual

CISCO 7800 SERIES

Standard Base for Cisco Headset 561 and 562

The Cisco Headset 561 and 562 come with a standard base to charge your headset. The base's LED display
shows the current battery level, and your call state. In addition to the call control buttons on the headset, you
can also answer and end calls when you lift or set down your headset on the base.
The connection between the base and the headset is made with Digital Enhanced Cordless Telecommunications
(DECT).
Figure 9: LED Display on the Standard Base for Cisco 561 and 562 Headset
The following table describes the standard base for Cisco 561 and 562 Headset.
Table 13: Standard Base for Cisco 561 and 562 Headset
Number Name
1 Battery Status LED
2 Call Status LED

Cisco Headset 561 and 562 with Multibase

The Multibase can connect up to three call sources through Bluetooth, USB connector, or Y-cable. Switch
between call sources using the button interface on the Multibase. You can answer and end calls by selecting
the call control buttons on your headset, or by lifting and returning your headset to the base. The multibase
comes with the following connector cables:
• USB to USB Cable: for Cisco IP Phones with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
GoMomentum.com
Description
Indicates the headset battery charge.
Alerts you to the call state:
• Incoming call—Blinking green.
• Active call—Steady green.
• Muted call—Steady red.
65
USER GUIDE
888.538.3960