Charge Cisco Headset 561 And 562 - Cisco 8841 User Manual

Num Name
1 Power and
(cont) Call button
2 Mute
button
3 Volume
button
+
and
4 LED

Charge Cisco Headset 561 and 562

Use the headset base to charge the headset.
1. Place the headset into the socket on the base.
The LEDs on the base station indicate the charging status. When the headset is fully charged,
the five LEDs on the base are steady white. If the LEDs don't light up, remove the headset from
the base and try again.
Cisco IP Phone 8841/8851 Multiplatform Phones User Guide
Description
Multiple calls:
1. Press once to put an active call on hold, and to
answer a second incoming call.
2. Press once to put a current call on hold and press
again to resume a call.
3. Press and hold for 2 seconds to end the current call
and press again to resume a held call.
4. Press and hold for 2 seconds to end an active call,
and to answer another incoming call.
5. Press twice to stay on a current call, and to reject a
second incoming call.
Toggle the microphone on and off. When Mute on the headset
is enabled:
•
The Mute button on the phone lights up.
•
The Mute button on the headset base lights up.
(For Multibase only.)
Adjust the volume on your headset.
–
Shows the headset status:
•
Blinking red—Incoming call.
•
Steady red—Active call.
•
Flashing white every 6 seconds—The headset is
paired and idle.
•
Blinking white—Firmware upgrade is in process or
the headset is pairing with the base station.
Accessories
63