System Enclosure; Overview Of Start-Up Procedures; Table 1-1. Start-Up Overview - Motorola PRPMC750 Installation And Use Manual

System Enclosure

The system enclosure requirements are determined by the configuration
and architecture of the baseboard (either VME, CompactPCI, or custom),
and with some exceptions usually requires only a single slot for both the
baseboard and the attached PrPMC750 (in a VME or CompactPCI
chassis). The exception would be if the PrPMC750 contained the optional
memory mezzanine board, which would place the entire PrPMC750
package 5.3mm over the allowed limit for a single slot, thereby requiring
two slots or a customized chassis that would accommodate slightly wider
board assemblies into each slot cavity.

Overview of Start-Up Procedures

The following table lists the things you will need to do before you can use
this board and tells where to find the information you need to perform each
step. Be sure to read this entire chapter and read all Caution and Warning
notes before beginning.
What you need to do ...
Unpack the hardware
Make any settings or adjustments
on the PrPMC750 module
Prepare any other optional devices
or equipment you will be using
Install the PrPMC750 on the
baseboard
Install the Optional Memory
Mezzanine on the PrPMC750
Connect any other optional devices
or equipment you will be using
http://www.motorola.com/computer/literature

Table 1-1. Start-Up Overview

Refer to ...
Unpacking the PrPMC750 Hardware
Preparing the PrPMC750 Hardware
PrPMC750 Configuration on page 1-5
For more information on optional devices and equipment,
refer to the documentation provided with that equipment
Installation of PrPMC750 on a VME or CompactPCI
Board on page 1-8
Installation of Optional SDRAM Mezzanine on
PrPMC750 on page 1-11
Connector Pin Assignments
For more information on optional devices and equipment,
refer to the documentation provided with that equipment
Overview of Start-Up Procedures
on page 1-5
on page 1-5
on page 4-1
1
1-3