Table of Contents
Advertisement
ATA Voice Field Reference
Line page
ATA Administration Guide
The SPA2102 provides one User tab for each Line tab (User 1 and User 2), where
many of the line-specific configuration parameters are contained. The SPA8000
does not provide User tabs, but consolidates all the line-specific parameters on
the Line tab.
Voice tab > Line page >
Line Enable section
Line Enable
Trunk Enable
Voice tab > Line page >
Streaming Audio Server (SAS) section
SAS Enable
SAS DLG Refresh
Intvl
To enable this line for service, select yes. Otherwise, select
no.
The default is yes.
To add this line to a trunk group, choose the trunk group
number. Otherwise, choose none. This feature is available
on the SPA8000 only.
The default is none.
To enable the use of the line as a streaming audio source,
select yes. Otherwise, select no. If enabled, the line cannot
be used for outgoing calls. Instead, it auto-answers
incoming calls and streams audio RTP packets to the caller.
The default is no.
If this value is not zero, it is the interval at which the
streaming audio server sends out session refresh (SIP re-
INVITE) messages to determine whether the connection to
the caller is still active. If the caller does not respond to the
refresh message, the ATA device ends this call with a SIP
BYE message. The range is 0 to 255 seconds (0 means that
the session refresh is disabled).
The default is 30.
B
166
Advertisement
Table of Contents
