Cisco SPA2102 Reconfiguration Manual

WARNING: THIS PROCEDURE DESCRIBES HOW TO MANUALLY RECONFIGURE A CISCO ATA SPA 2102
AND 8000 TO WORK ON THE BROADSOFT BROADCLOUD PBX NETWORK. ONCE THIS PROCEDURE
HAS BEEN COMPLETED, ANY PRIOR CONFIGURATION SETTINGS ON THE DEVICE WILL BE
OVERRIDDEN, INCLUDING THE ADMINISTRATOR PASSWORD, AND THE DEVICE WILL ONLY BE
USABLE ON THE BROADSOFT BROADCLOUD PBX NETWORK. THE DEVICE MUST BE RETURNED TO
THE CISCO FACTORY DEFAULT CONFIGURATION BEFORE IT CAN BE USED ON ANY NETWORK OTHER
THEN BROADSOFT BROADCLOUD PBX.
For Models: SPA2102 and 8000
1. Connect an analog phone into line one of the device
2. Press the start key four times "****"
3. Press "110#" and record the IP address
4. From a browser on the same LAN, enter the IP address recorded in step 3
Note:
• If prompted for a user and password, enter it now. Then click admin and enter the
admin
user and password.
• For 2102 only. If the browser does not take you to the SPA webpage, you must
activate
the web utility. Redo step 2 and then enter "7932#", "1#"' "1"
5. Click the admin link in the top right of the page
6. Click the advanced link in the top right of the page
7. Click the "Voice" tab
8. Click the "Provisioning" tab
9. Enter the following link in "Profile Rule"
North America: **
For All Devices - Enter
** If you are having trouble flashing your device with these URLs, please contact
your technical support team for assistance.
Europe (only SPA8000):
https://spa.sipflash.com/
https://spa.broadcloud.eu/
Cisco SPA2102 and 8000 ATA
Manual Reconfiguration Guide