Cisco Small Business Pro SPA3102 Administration Manual page 159

ATA Voice Field Reference
Regional page
ATA Administration Guide
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing
Modem Line Toggle
Code
FAX Line Toggle
Code
Referral Services
Codes
the third party for a call transfer. Enter the code for a call
transfer.
Toggles the line to a modem.
The default is *99. Modem pass-through mode can be
triggered only by pre-dialing this code.
Toggles the line to a fax machine. This field is not found in
the PAP2T.
The default is #99.
These codes tell the ATA device what to do when the user
places the current call on hold and is listening to the
second dial tone.
One or more *code can be configured into this parameter,
such as *98, or *97|*98|*123, etc. Max total length is 79
chars. This parameter applies when the user places the
current call on hold (by Hook Flash) and is listening to
second dial tone. Each *code (and the following valid target
number according to current dial plan) entered on the
second dial-tone triggers the ATA device to perform a blind
transfer to a target number that is prepended by the
service *code.
For example, after the user dials *98, the ATA device plays
a special dial tone called the Prompt Tone while waiting for
the user the enter a target number (which is checked
according to dial plan as in normal dialing). When a
complete number is entered, the ATA device sends a blind
REFER to the holding party with the Refer-To target equals
target_number
to *98
hand off a call to an application server to perform further
processing, such as call park.
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA device. You
can empty the corresponding *code that you do not want
to ATA device to process.
. This feature allows the ATA device to
B
157