ATA Routing Field Reference
LAN Setup page
LAN Setup page
ATA Administration Guide
Maximum Uplink
Speed
Router tab > WAN Setup page >
VLAN Settings section
Enable VLAN
VLAN ID
You can use the LAN Setup page to enter your LAN settings. This page includes
the following sections:
•
"Networking Service section," on page117
•
"LAN Networking Settings section," on page118
•
"Static DHCP Lease Settings section," on page118
Router tab > LAN Setup page >
Networking Service section
Networking Service
The maximum bandwidth for LAN to WAN throughput.
The default is 128 kbps.
Allows (yes) or prevents (no) VLAN access.
NOTE:
Choose yes if your ATA device is connected to
a switch that uses VLAN tagging.
The VLAN tag for the VLAN to which the ATA device is
assigned.
Options are NAT or Bridge.
NAT—the unit acts as a router and provides IP
addresses to PCs attached to the LAN port.
Bridge—The unit acts as a switch, a passthrough, and
does not give IP addresses.
A
117