Resync Url - Cisco Small Business Pro SPA3102 Administration Manual

Basic Administration and Configuration
Upgrading, Rebooting, and Resyncing Your ATA Device
NOTE
NOTE
ATA Administration Guide
If the value of the Upgrade Enable
cannot upgrade the ATA device even if the web page indicates otherwise.
The syntax of the Upgrade URL is as follows:
http://spa-ip-addr/admin/upgrade?[protocol://][server-name[:port]][/
firmware-pathname]
Both HTTP and TFTP are supported for the upgrade operation.
protocol
If no is specified, TFTP is assumed. If no
host that requests the URL is used as
If no port specified, the default port of the protocol is used. (69 for TFTP or 80 for
HTTP)
firmware-pathname
The
directory on the TFTP or HTTP server. If no
spa.bin
is assumed, as in the following example:
http://192.168.2.217/admin/upgrade?tftp://192.168.2.251/spa.bin

Resync URL

The Resync URL lets you force the ATA device to do a resync to a profile specified
in the URL, which can identify either a TFTP, HTTP, or HTTPS server. The syntax of
the Resync URL is as follows:
http://spa-ip-addr/admin/resync?[[protocol://][server-name[:port]]/profile-
pathname]
The SPA resyncs only when it is idle.
If no parameter follows
page is used.
protocol
If no is specified, TFTP is assumed. If no
host that requests the URL is used as
If no port is specified, the default port is used (69 for TFTP, 80 for HTTP, and 443
for HTTPS).
parameter in the Provisioning page is No, you
server-name
is typically the file name of the binary located in a
firmware-pathname
/resync?, the Profile Rule setting from the Provisioning
server-name
server-name
is specified, the
.
is specified,
server-name
is specified, the
.
2
/
43