Cisco Small Business Pro SPA3102 Administration Manual page 112

Configuring the PSTN (FXO) Gateway on the SPA3102
Call Scenarios
ATA Administration Guide
Forward to a Particular PSTN Number
In this scenario, the forward destination is set to <
the same as in the previous examples, except that the ATA device automatically
dials the given target number on the PSTN line right after it answers the VoIP call
leg. This is a special case of one-stage dialing where the target number is
specified in the configuration. The caller is not authenticated in this case
regardless of the authentication method. However, the caller is still limited by the
VoIP Caller ID Pattern
Forward-On-Busy to PSTN Gateway or Number
This scenario is similar to the previous cases of call forwarding to gw0, but this
applies when Line 1 is active.
parameter
target-number>@gw0
6
>. This is
110