Gm Operation; Setting Up Gm Operation - Standard Horizon QUANTUM AIS GX6000E Owner's Manual

12 GM OPERATION

The GM (Group Monitor) feature of the GX6000E utilizes the same system as
the DSC Group call and Auto Position Polling, to display the group members'
locations.
12.1

SETTING UP GM OPERATION

The GX6000E is capable of storing up to 10 groups with 1 to 9 members each.
12.1.1 Setting Up GM Group Directory
• For this function to operate, the same group MMSI must be programmed
into each transceiver of group members to be monitored. Refer to
section "10.5.1 Setting up a Group Call" for details.
• Group members for GM operation can only be selected from the
Individual/Position Call directory, there for all members that you want
to monitor have to be stored in the directory. Refer to section "10.4.1
Setting up the Individual / Position Call Directory" for details.
[ ]  "SETUP"  "GM SETUP"  "GM GROUP DIRECTORY"
1.
2. Rotate the DIAL/ENT knob to select "ADD", then
press the [SELECT] soft key.
3. Rotate the DIAL/ENT knob to select "NAME:", then
press the [SELECT] soft key.
4. Enter the route name by rotating the DIAL/ENT knob
and the [SELECT] soft key.
When finished entering the name (using eleven char-
acters or less), press the [FINISH] soft key.
5. Rotate the DIAL/ENT knob to select "GM ID:", press
the [SELECT] soft key, then enter the group MMSI
number.
When finished entering the MMSI, press the [FINISH]
soft key.
6. Rotate the DIAL/ENT knob to select "MEMBER", then
press the [SELECT] soft key.
GX6000E
NOTE
Page 95