19 ATIS SETUP
The GX6000E supports the ATIS (Automatic Transmitter Identification System)
used in Inland waterways in Europe. When enabled ATIS mode transmits a
unique ATIS code each time the PTT switch is released at the end of a trans-
mission.
Users should check with their local marine regulatory authority in their country
for assistance in obtaining an ATIS code.
19.1
ATIS CODE PROGRAMMING
[
] "SETUP" "ATIS SETUP" "ATIS CODE"
1.
2. Rotate the DIAL/ENT knob to select the first number
of your ATIS, then press the [SELECT] soft key to
step to the next number.
3. Repeat step 2 to set your ATIS (ten digits).
4. If a mistake was made entering in the ATIS, Rotate
the DIAL/ENT knob to select "←" or "→", press the
[SELECT] soft key until the wrong number is selected,
then perform step 2.
5. When finished programming the number, press the
[FINISH] soft key. The Radio will ask you to input the
ATIS number again. Perform steps 2 through 4 above.
6. After the second number has been input, press the
[FINISH] soft key to store the ATIS number in memory.
7. Press the [OK] soft key to return to radio operation.
GX6000E
Page 135