Standard Horizon QUANTUM AIS GX6000E Owner's Manual page 31

3. Press the [MMSI] soft key.
The [MMSI] soft key is displayed which has not yet
set the MMSI.
In the case of the GX6000E which has completed
the MMSI setting, you can only check the MMSI on
this screen.
4. Rotate the DIAL/ENT knob to select the first number
of your MMSI, then press the [SELECT] soft key to
step to the next number.
5. Repeat step 4 to set your MMSI number (9 digits).
6. If a mistake was made entering in the MMSI number,
rotate the DIAL/ENT knob to select "←" or "→", press
the [SELECT] soft key until the wrong character is
selected, then perform step 4.
7. When finished programming the MMSI number, press
the [FINISH] soft key. The radio will ask you to input
the MMSI number again. Perform steps 4 through 6
above.
8. After the second number has been input, press the
[FINISH] soft key to store the MMSI.
9. Press the [OK] soft key to return to radio operation.
To view your MMSI after programming to ensure it is correct, perform
steps 1 to 2. Look that the MMSI number shown on the display is correct.
GX6000E
NOTE
*********
Page 29