Pair The Usb Hd Adapter To Your Headset; Alternate Between Active Bluetooth Sources; Delete Paired Devices - Cisco Headset 730 User Manual

Your Headset

Pair the USB HD Adapter to Your Headset

You can re-pair your USB HD Adapter if you have erased your headset's Bluetooth pairings or need to replace
your adapter.
Procedure
Step 1
Connect the USB HD Adapter to your chosen device.
Step 2 Use a pen or a paper clip to press down the Pairing button on the USB HD Adapter for four seconds. The
blue LED on top of the adapter blinks when it enters pairing mode.
Step 3 On your headset, slide and hold the Power/Bluetooth switch for two seconds. The adapter and your headset
pair automatically.

Alternate Between Active Bluetooth Sources

You can connect up to two Bluetooth devices to your headset at one time. Active calls are automatically placed
on hold when you answer a call on a different source.
Procedure
To change your Bluetooth source, play music or answer a call on a different connected source.
Note

Delete Paired Devices

You can erase all paired Bluetooth devices from your headset.
Note This will also erase the Cisco Headset USB HD Adapter from your headset's memory. See
Adapter to Your Headset, on page 7
Procedure
Slide and hold the Power/Bluetooth switch for nine seconds. If audible notifications are enabled, your headset
plays an audio prompt when it erases all Bluetooth devices.
Pause music playback before you switch to a different music source.
to re-pair the adapter to your headset.
Pair the USB HD Adapter to Your Headset
Pair the USB HD
Cisco Headset 730 User Guide
7