Bluetooth Led - Cisco Headset 730 User Manual

Your Headset
Note If you already have two active Bluetooth sources, you must disconnect one before you can save another
Bluetooth device to your headset.
Procedure
Step 1 Slide up and hold the Power/Bluetooth switch for two seconds until the Bluetooth LED blinks.
Step 2
Enable Bluetooth on your device.
You can enable and disable Bluetooth from the Settings menu on most call devices.
Step 3 Select your headset from the device list.
Your headset will appear in the device list as Cisco Headset 730 followed by the last three digits of your
headset serial number.
Related Topics

Bluetooth LED

The Bluetooth LED is located on the back of the left ear cup at the top of the Power/Bluetooth switch and
shows your headset connection status.
Table 1: Bluetooth LED Status
Light Status
Solid blue, then off
Your Headset Serial Number, on page 38
System State
Successful Bluetooth connection
Cisco Headset 730 User Guide
Bluetooth LED
5