Control Panel Overview - Black & Decker BDXBTAGVAR Instruction Manual

Page 10 ENGLISH
Installation & Operation Manual

3.9 Control Panel Overview

CAUTION
If power is connected to the Variable Speed Pump motor, pressing any of the
following buttons referred to in this section could result in the motor starting. Failure to recognize this
could result in personal injury or damage to equipment.
Keypad Navigation
1. Button "LOW/ ": used to select the fixed LOW speed or to decrease speed while in the programming mode.
2. Button "MED/OK": used to select the fixed MEDIUM speed or to confirm/save parameters while in the
programming mode.
3. Button "HIGH/ ": used to select the fixed HIGH speed or to increase speed while in the programming mode.
4. LED display window: displays the current speed of the motor, or error code message.
5. "SET" button: used to enter the programming mode or to reset the control.
6. Button " ": used to STOP the motor.
7. Error light: illuminates when there is a fault detected.
8. Power light: illuminates when power turns on.
Starting the Pump
To start the pump press the button "1", "2", or "3" to select the preset fixed speed. If the pump starts
from standby mode, it starts up and subsequently runs with the selected fixed speed.
The default speed settings are as follows.
Speed 1 = 1600 rpm
Speed 2 = 2600 rpm
Speed 3 = 3450 rpm
The pump will automatically change from selected speed "3" to speed "1" after 2 hours of run time.
The pump will automatically change from selected speed "2" to speed "1" after 24 hours of run time.