Control Panel Overview - Black & Decker BDXBTVAR150 Instruction Manual

Page 6 ENGLISH

2.4 Control Panel Overview

(1) Speed Buttons
(8) "+" and "-"
Arrows
(7) "<" and ">"
Arrows
(2) Mode Select
Button
If power is connected to the Variable Speed Pump motor, pressing any of the
following buttons referred to in this section could result in the motor starting. Failure to recognize this
Keypad Navigation
1. Speed Buttons - Used to select the run speed desired. The LED above the Speed Buttons will illuminate when
that speed is selected or is currently running. A flashing LED indicates is active on that speeds channel.
2. Mode Select Button - Choose manual and schedule.
3. Start/Stop Button - Used to start and stop the pump. When the pump is stopped and the LED is not illuminated,
the pump is unable to run from any type of input.
4. Display Mode LED Indicators - An illuminated LED indicates the information being displayed on the screen at
any specific point. A flashing LED indicates that the parameter is currently being edited.
5. Display Button - Used to toggle between the different available display modes. This button is also used to set
the 24-hour clock and screen resolution.
6. Quick Clean Button - Used to run a selected speed and duration programmed for Quick Clean. When the LED
is illuminated the Quick Clean schedule is active.
7. "<" and ">" Arrows - Choose between a 12- or 24-hour time format.
8. "+" and "-" Arrows - Used to make on-screen adjustments to the pump settings. The "+" arrow increases the
value of a given setting, while "-" decreases the value of a given setting. Pressing and holding down either arrow
button will increase or decrease the incremental changes faster.
could result in personal injury or damage to equipment.
CAUTION
Installation & Operation Manual
(4) Display Mode
LED Indicators
(5) Display Button
(6) Quick Clean
Button
(3) Start/Stop
Button