Honeywell JetWave MCS-8562 Installation And Maintenance Manual page 77

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
Cable Conductor Type
A429 Twisted pair, stranded
RS-422 Twisted pair, shielded
Discrete Twisted pair, shielded, KANDU
Single conductor, shielded, grounds
When installing the JetWave™ MCS-8562 Terminal, follow the cabling requirements listed below:
- Ethernet LAN/WAN cables must meet flammability and TIA/EIA568-A CAT 5E requirements.
- When routing JetWave™ MCS-8562 Terminal signals, avoid long wiring runs adjacent with other signals
that could increase the risk of Electro-Magnetic Coupling.
- Carlisle IT (ECS) 422404 or NF24Q100-01 is recommended for Quadrax connections.
- Twisted shielded pairs must meet ARINC 791 wiring requirements or equivalent.
Refer to Figure 3-12 for wire size recommendations.
Refer to Figure 3-6 for the Modman (PN 90400012-0001) outline and installation drawing.
Refer to Figure 3-7 for the Modman (PN 90400012-0002) outline and installation drawing.
Refer to Figure 3-8 for the APM (PN 90401121) outline and installation drawing.
Refer to Figure 3-9 for the KANDU (PN 90404518) outline and installation drawing.
Refer to Figure 3-10 for the BUC-HPA (PN 90003227-003), conduction-cooled 1 (maximum operating
temperature of 185°F (85°C)), outline and installation drawing.
Refer to Figure 3-11 for the FMA (PN 90002609-001) outline and installation drawing.
Refer to Figure 3-12 for the JetWave™ MCS-8562 Terminal - FMA (90410870) system interconnect diagram.
EFFECTIVITY
ALL
© Honeywell International Inc. Do not copy without express permission of Honeywell.
JetWave™ MCS-8562 Terminal
Table 3-8. Cabling Requirements (Cont)
23-15-84
Single Multiple Minimum Conductor
Point Point Coverage by Shield
- Yes 95%
- Yes 100%
- Yes 100%
Page 3-25
11 Nov 2020