Honeywell JetWave MCS-8562 Installation And Maintenance Manual page 72

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
(d)
(e)
(f)
(2) FMA Bonding Requirements
(a)
(b)
EFFECTIVITY
ALL
© Honeywell International Inc. Do not copy without express permission of Honeywell.
JetWave™ MCS-8562 Terminal
Figure 3-4. FMA Assembly Lifting Fixture Removal
The orientation of the FMA assembly is defined with respect to the principal axes
of the aircraft.
Attach the FMA to the AIM with screws and flat washers. The AIM is provisioned
with captive nuts. Refer to the airframe specific kits and assembly for fastener
specifications and required torque. Mounting holes in base are accessed from the
top between the antenna and turntable by rotating the assembly in azimuth.
Remove protective cap from disconnect plug on harness.
1 Visually inspect connector and make sure that there are no debris in
cavities.
2 Visually inspect the center conductor and verify that it is still straight and
the finish is intact.
Install one end of bonding straps to AIM at labeled bonding points with screw and
washers.
Install the other end of bonding straps to bonding points on the FMA base. Refer
to the airframe specific kits and assembly for fastener specifications and required
torque.
23-15-84
Page 3-20
11 Nov 2020