Miscellaneous Options 2; Synchronize Strobes Active During Silence; Auto Display Oldest Event; Report By Zone Or By Point - Honeywell Silent Knight IntelliKnight 5820XL Installation And Operation Manual

7.6.5

Miscellaneous Options 2

Through this programming option you can turn the strobe synchronization during silence
feature On or Off, and select the control panel to report events by zone or by point.
To edit miscellaneous options 2:
1. Enter the installer code.
2. Press to display the main menu.
or
3. Select for Program Menu.
7
Display reads:
4. Select for System Options.
5
5. Select for Miscellaneous Options 2.
6

7.6.5.1 Synchronize Strobes Active During Silence

When "SYNC Strbs w/ Sil:" is Selected as Y (Yes) then strobes will continue to flash when the
system is silenced and will stop flashing when the system is reset.
Note: The "SYNC Strbs w/ Sil:" only functions with outputs that use a synchronized output pattern.
6. Press the or
7. Press to make your selection and move to the next programming option.
or
Note: See Section 7.3.1.4 for more information about Synchronization protocol choices.

7.6.5.2 Auto Display Oldest Event

When this feature is programmed Y (Yes) then the oldest un-acknowledge event will
automatically display on the control panel and remote annunciators after there has been no
activity on any system touchpad for two minutes.
8. Press the or
9. Press to make your selection and move to the next programming option.
or

7.6.5.3 Report by Zone or by Point

When the "Report by" option is set to Zone, then the control panel will report events by zone.
If Point is selected then the control panel will report events by point.
10. Press the or
11. Then press
or
151209
Initializing
Please wait . . .
arrow to toggle this selection between Y (Yes) or N (No).
arrow to toggle this selection between Y (Yes) or N (No).
arrow to toggle this selection between Zone or Point.
. See Section 9 for reporting codes.
firealarmresources.com
Programming
7-41