Table of Contents
Advertisement
Operation
Occurs When
Mode
Prealarm
A single detector
trips in a 2-
Count zone. (2-
Count means
two detectors
must trip before
an alarm is
reported.)
Reset
RESET
The
button is pressed
followed by a
valid code or
rotation of the
key.
Silenced
An alarm or
trouble
condition has
been silenced
but still exists.
To silence
alarms and
troubles, press
SILENCE
followed by the
Installer or User
Code or rotate
the key.
151209
Table 8-1: Operation Mode Behavior
System Behavior
Touchpad PZT beeps.
The LCD displays a screen similar to this
one.
All LEDs are on briefly then the LCD
displays "ALARM RESET IN
PROGRESS". If the reset process
completes normally, the date and time
normal mode screen displays.
SYSTEM SILENCE LED is on. SYSTEM
TROUBLE, SUPERVISORY or
GENERAL ALARM LED (depending on
condition) is on. The annunciator (and any
notification devices attached to the
system) will be silenced.
firealarmresources.com
System Operation
In This Mode You Can
Press
(down arrow) to view the prealarm. A
screen similar to this one displays.
All system operations are available in this mode.
Menus are not available during the reset process.
Press
(down arrow) to view the location of the
alarm or trouble. When the condition no longer
exists, the SYSTEM SILENCED and SYSTEM
TROUBLE LED, SUPERVISORY or GENERAL
ALARM LEDs turn off.
8-13
Advertisement
Table of Contents
Troubleshooting
