Table of Contents
Advertisement
1.2
ENERVISTA MII SETUP SOFTWARE
The ENERVISTA MII SETUP software interface is the preferred method to edit settings and view actual values
because the PC monitor can display more information in a simple comprehensible format.
The following minimum requirements must be met for the ENERVISTA MII SETUP software to properly operate on a
PC:
Pentium® class or higher processor (Pentium® II 300 MHz or higher recommended)
Windows® NT 4.0 (Service Pack 3 or higher), Windows® 2000, Windows® XP
Internet Explorer® 5.0 or higher
64 MB of RAM (128 MB recommended)
40 MB of available space on system drive and 40 MB of available space on installation drive
RS232C serial and Ethernet port for communications to the relay
After ensuring the minimum requirements for using EnerVista MII Setup are met (see previous section), use the
following procedure to install the EnerVista MII Setup from the enclosed GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install the no-charge EnerVista software.
3. When installation is complete, start the EnerVista Launchpad application.
4. Click the IED Setup section of the Launch Pad window.
5. In the EnerVista Launch Pad window, click the Add Product button and select the "MIFII Digital Feeder Relay"
from the Install Software window as shown below. Select the "Web" option to ensure the most recent software
GEK-106273L
GETTING STARTED
FIGURE 1-1
MIF Digital Feeder Protection
1.2.1.
SYSTEM REQUIREMENTS
1.2.2.
INSTALLATION
1-3
Advertisement
Table of Contents
