Replacing The Fesmic - Cisco 3200 Series Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Replacing the FESMIC

To replace the FESMIC, follow these steps:
If WMIC 3 is present, remove WMIC 3 and WMIC 2 as one unit. If only WMIC 2 is present, remove it.
Step 1
Disconnect the LED cable from the back of the FESMIC.
Step 2
Remove the FESMIC.
Step 3
Make sure that the rotary switch on the new FESMIC (see
Step 4
on the SMIC.
For example, if the SMIC rotary switch is set to 1, then set the FESMIC switch to 0, and vice versa.
Figure 2-8
1
Verify that all ISA and PCI connector pins on the new FESMIC are straight and not bent.
Step 5
Connect the new FESMIC card to the SMIC card by aligning the bus headers and firmly pressing the
Step 6
cards together.
Note
Step 7 Connect WMIC 2 (or WMIC 2 and WMIC 3 as one unit) to the FESMIC card as described in the
a New WMIC" section on page
Connect the LED cable to the back of the FESMIC.
Step 8
OL-15983-01
FESMIC and SMIC Rotary Switches
FESMIC rotary switch.
Be sure not to bend any exposed pins on the card while squeezing the cards together.
2
SMIC rotary switch.
2-7.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure 2-8) is set opposite to the rotary switch
1
2
"Adding
2-9