Card Replacement Process
Figure 3-12
1
1
Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
3
Connect the FESMIC 10-pin FE3X cable to
WMIC 1.
For a 2-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-13
1
5
1
Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
3
Connect the FESMIC 10-pin FE3X cable to
WMIC 1.
5
Connect the WMIC 2 console port to port J2
on the wiring card, using a 20-pin cable.
Cisco 3200 Series Router Hardware Upgrade Guide
3-12
1-WMIC Configuration
2
2-WMIC Configuration
2
Chapter 3
Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
3
4
2
Connect the FESMIC 10-pin FE2X cable to
port J4 on the wiring card.
4
Thread the FE extender cable under the card
stack to the antenna end cap side.
3
4
2
Connect the FESMIC 10-pin FE2X cable to
WMIC 2.
4
Thread the FE extender cable under the card
stack to the antenna end cap side.
Figure
3-13.
OL-15983-01