Attaching The Version 2 Of The Wiring Card - Cisco 3200 Series Upgrade Manual

Card Replacement Process
c.
d.
e.
f.
g.

Attaching the Version 2 of the Wiring Card

If you are using the newer version 2 of the wiring card (see
to reattach it to the card stack:
Step 1 Install the wiring card (shown attached to the front of the card stack in
a.
b.
Install the cables. The wiring card has a label beside to each port (J3, J4, and so forth).
Step 2
For a (0-) or 1-WMIC configuration, connect the cables to the wiring card as shown in
Figure 2-12
5
1
Cisco 3200 Series Router Hardware Upgrade Guide
2-14
If there is a second WMIC in the stack, attach a console cable (72-4281-01) to the J2 header on the
wiring card. Attach the other end of the cable to the LED header on the second WMIC (at the top of
the card stack).
Route the LED ribbon cable (72-4279-01) over the top of the card stack. The connector closest to
the label should be toward the back of the extrusion.
Connect the LED ribbon cable to J5 of the wiring card and to the FESMIC LED header on the card
stack at the back of the extrusion.
Route the power cable from the I/O end cap under the card stack, toward the back of the extrusion.
Connect the power cable to the header on the MRPC.
Align the wiring card connectors with the headers on the card stack at the front of the extrusion.
Secure the wiring card to the extrusion with the card's eight Phillips pan-head screws. The sequence
use for tightening the wiring card is indicated by the circled numbers in
range of 5.5 to 5.7 in-lb when tightening the wiring card.
0- or 1-WMIC Configuration
Connect the FESMIC 10-pin FE3X cable to
WMIC 1, if WMIC is present.
Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure
Figure 1-8 on page
Figure
1
2
Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
1-8), follow these steps
2-11).
Figure 2-5. Use a torque
Figure 2-12.
OL-15983-01