Reattaching The Antenna End Cap - Cisco 3200 Series Upgrade Manual

Card Replacement Process

Reattaching the Antenna End Cap

To reattach the antenna end cap, follow these steps:
If you have added new WMICs, remove the corresponding antenna end cap plugs from the antenna end
Step 1
cap and replace them with RP-TNC connectors.
Attach the antenna cables to the antenna end cap, as shown in
Step 2
Attach the antenna identification labels for the new WMICs on the antenna end cap's exterior, as shown
Step 3
in Figure
Figure 3-16
1
1
Use a 3/8-inch socket to secure the antenna end cap with four 1/4-20 x 1 1/4-inch-long bolts. The torque
Step 4
range for the antenna end cap bolts is 58 to 68 in-lb.
Cisco 3200 Series Router Hardware Upgrade Guide
3-16
3-16. (Figure 3-16 shows one new label being applied over an old label.)
Attaching Antenna Labels
Label
Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
Figure 2-2.
OL-15983-01