Replacing Or Adding A New Card; Adding A New Wmic - Cisco 3200 Series Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure
Step 3 Slide the card stack out from the I/O end cap side.
Step 4 Carefully place the card stack on its side on a rugged flat surface.

Replacing or Adding a New Card

This section describes how to add a WMIC to the stack and how to replace a WMIC, Mobile Router
Power Care (MRPC), Serial Mobile Interface Card (SMIC), or Fast Ethernet Switch Mobile Interface
Card(FESMIC).
To ensure that cards can be installed properly, prevent the card pins from getting bent.
Caution

Adding a New WMIC

To add a new WMIC card to the card stack, follow these steps:
Attach the antenna cables to the WMIC.
Step 1
We recommend that you label the free end of the antenna cables as primary and secondary, and that you
identify the WMIC to which they are associated. We recommend that you associate the primary cable
with MAIN and the secondary cable with AUX.
Figure 2-6
the secondary cable attached to the AUX antenna cable connector.
Figure 2-6
OL-15983-01
shows a WMIC with the primary cable attached to the MAIN antenna cable connector and
Antenna Connectors
MAIN
AUX
PRIMARY
MAIN AUX
PIMARY
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
2-7