Sfp Module Replacement Process - Cisco 3200 Series Upgrade Manual

SFP Module Replacement Process

To prevent electrostatic damage to cards in the rugged enclosure, attach an ESD-preventive wrist strap
Caution
to your wrist and to a bare metal surface on the chassis of the enclosure before you start the SFP
replacement process.
SFP Module Replacement Process
This section describes how to replace an SFP module.
Class 1 laser product. Statement 1008
Warning
To insert an SFP module into the SFP module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Caution
Remove the antenna end cap by using a 3/8-inch socket wrench to loosen the bolts.
Step 4
Disconnect the (LC) from the SFP module.
Step 5
Tip
Step 6 Insert a dust plug into each optical port of the SFP module to keep the optical interfaces clean.
Caution
Unlock and remove the SFP module, as shown in
Step 7
Figure 4-2
A
Step 8 Pull the bale-clasp latch out and down to eject the module. If the bale-clasp latch is obstructed and you
cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Cisco 3200 Series Router Hardware Upgrade Guide
4-2
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
To avoid damaging the optical surface, do not touch the optical surfaces.
Disconnecting SFP Latch Mechanisms
1
B
Figure 4-2.
2
Chapter 4 Replacing the SFP Module
3 4
OL-15983-01