Reattaching The Wiring Card - Cisco 3200 Series Upgrade Manual

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Reattaching the Wiring Card

To reattach the wiring card to the card stack, follow these steps:
Attach the wiring card to the front of the card stack by aligning ports and firmly pressing the card into
Step 1
the stack.
If WMICs are present, make sure that the WMIC mounting boss is within 0.01 inch of the wiring card.
Step 2
Using a Phillips screwdriver, tighten the wiring card screws using 5.5 to 5.7 in-lb torque, as shown in
Step 3
Figure
Note
Connect the cables to the wiring card, as shown in
Step 4
For a 0-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-11
1
1
3
For a 1-WMIC configuration, connect the cables to the wiring card as shown in
OL-15983-01
3-4.
In a 0-WMIC configuration, screw number 2 is not used.
0-WMIC Configuration
Connect the FESMIC 10-pin FE1X cable to
port J14 on the wiring card.
Connect the FESMIC 10-pin FE2X cable to
port J4 on the wiring card.
Figure 3-11.
2
3
4
2 Connect the FESMIC 10-pin FE3X cable to
port J16 on the I/O card.
4
Thread the FE extender cable under the card
stack to the antenna end cap side.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure 3-11.
Figure 3-12.
3-11