Cisco 3200 Series Upgrade Manual page 49

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
For a 3-WMIC configuration, connect the cables to the wiring card as shown in
Figure 3-14
6
5
1
Connect the FESMIC 10-pin FE1X cable to
WMIC 3.
3 Connect the FESMIC 10-pin FE3X cable to
WMIC 1.
5
Connect the WMIC 2 console port to port J2
on the wiring card, using the 20-pin cable.
Connect the 60-pin Serial Mobile Interface Card (SMIC) serial console connector cable to port J13 on
Step 5
the wiring card.
Connect the 20-pin FESMIC LED cable to port J5 on the wiring card.
Step 6
Note
OL-15983-01
3-WMIC Configuration
1 2
When connecting the serial console and LED ribbon cables, use them to secure the other cables
connecting the card stack to the wiring card.
3
4
2
Connect the FESMIC 10-pin FE2X cable to
WMIC 2.
4 Thread the FE extender cable under the card
stack to the antenna end cap side.
6
Connect the WMIC 3 console port to port J3
on the wiring card using a 20-pin cable.
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
Figure 3-14.
3-13