Connecting An Uninteruptible Power Supply Ups To An Ac-Powered Cisco Iad2430 Series Iad - Cisco IAD2430 Series Hardware Installation Manual

Connecting Backup Power
Figure 3-30 Connecting a Backup Battery to a DC-Powered Cisco IAD
AC wall plug
Use a backup battery only if you are not using AC to power your Cisco IAD2430 series IAD. Do not use
Caution
AC and DC power at the same time. If you do, the unit stops operating, and you must reboot it with only
a single power source
Figure 3-31
connector on Cisco IAD2430 series IADs.
Table 3-7
Pin Number
1
2
3
4
Figure 3-31
Connecting an Uninteruptible Power Supply UPS to an AC-Powered
Cisco IAD2430 Series IAD
Connect an uninterruptible power supply (UPS) to the AC input on your Cisco IAD2430 series IAD.
Before you install a UPS, be sure to read the installation instructions for the UPS.
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-34
Battery backup
shows the DC power connector. See
Pinouts for DC Power Connector
Description
GND (input enable)
+12V (power)
REP_BAT (replace battery)
GND (power return)
DC Power Connector
Chapter 3
Cisco IAD 2430 series
Table 3-7 for pinout information for the DC power
Pin Number
5
6
7
8
IA D 24 31
-8 FX S
Pin 5
Pin 1
Installing Cisco IAD2430 Series IADs
IAD 243 1-8
FX S
DC plug
Description
ON_BAT (battery is on)
+12V (power)
LOW_BAT (battery is low)
GND (power return)
OL-4234-06