Cisco IAD2430 Series Hardware Installation Manual page 14

Integrated access devices
Hide thumbs Also See for IAD2430 Series:
Table of Contents

Advertisement

Product Serial Number Location
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool. Statement 1035
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
Warning
locations. Statement 1036
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface. Statement 1037
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning. Statement 1038
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Product Serial Number Location
The serial number label for the Cisco IAD2430 series routers (Cisco IAD2430 through Cisco IAD2432)
is located on the back of the chassis, near the compliance label. The size of the serial number label is
0.25 x 1 inch (0.635 x 2.54 centimeters). It has the letters "SN:" followed by eleven characters. (See
Figure
chassis, near the compliance label. (See
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
xiv
0-1.) The serial number label for the Cisco IAD2435 series IAD is located on the bottom of the
Figure
0-2.)
Preface
OL-4234-06

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents