Connecting The Input Power; Cable; Procedure; Connecting Input Power On The Cisco Iad2435 Iad - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
1
3

Connecting the Input Power

To connect input power to the Cisco IAD, use the procedure in this section.
The Cisco IAD2430 series chassis provides inputs for both AC and DC power. Design your installation
Caution
to use only one type of power. Do not use AC and DC power at the same time. If you do, the unit stops
operating, and you must reboot it with only a single power source.

Cable

The AC power cable is used for this application.

Procedure

Connect the AC power cable (supplied) to the recessed power plug on the back of the concentrator.
Step 1
Plug the cable into a power source with a voltage of 100 to 240 VAC.
Step 2

Connecting Input Power on the Cisco IAD2435 IAD

To connect input power to the Cisco IAD2435, perform the following steps:
Step 1 Connect the router to an AC power outlet as shown in
Step 2 To secure the power cord to the router, attach the power lock clip to the power cord, and slide the clip
to the end of the DC plug. See location 1 in
OL-4234-06
Fast Ethernet port
Fast Ethernet (straight-through)
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
2
Serial port—console or auxiliary
4 RJ-45-to-DB-9 console cable
Figure 3-19.
Figure 3-19.
Connecting Cables
3-21