Cisco IAD2430 Series Hardware Installation Manual page 46

Wall-Mounting the Chassis
Be sure to use the correct screws and plastic washers for this mounting option. (See
Caution
page 3-7.)
Figure 3-9
Step 2 Attach the second bracket to the opposite side of the chassis.
Step 3 Attach the router to the wall using the brackets previously attached and using attachment hardware that
you provide as follows:
• You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds
the unit in place for easy installation of the attachment screws.
Attach both brackets to the wall.
•
Note
Note
Figure 3-10
•
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-10
Attaching the Brackets for Wall-Mounting
For attaching to a wall stud, each bracket requires two number 10 wood screws (round- or
pan-head) with number 10 washers, or two number 10 washer-head screws. The screws must
be long enough to penetrate at least 3/4-inch (20-mm) into the supporting wood or metal
wall stud.
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall
anchors and washers must be size number 10.
shows the orientation required for installation.
Chapter 3 Installing Cisco IAD2430 Series IADs
Table 3-1 on
OL-4234-06