Connecting Cables
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
Warning
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call. Statement 1042
Procedure
Connect the RJ-21 cable from the analog voice multiport to the distribution panel. See
Step 1
Figure 3-28
Use the strap to secure the cable in place.
Step 2
Connecting the Digital Voice Port to a T1/E1-PBX
To connect the digital voice port to a digital PBX, use the procedure in this section.
Cable
Use an RJ-48 T1/E1 cable (not included).
Procedure
Connect the RJ-48 T1/E1 cable to the T1/E1 port. See
Step 1
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
3-30
Analog Voice Connection
RJ-21 cable
Chapter 3
Installing Cisco IAD2430 Series IADs
Distribution panel
Figure
3-29.
Figure
3-28.
OL-4234-06