Table of Contents
Advertisement
3. Loosen jam nut on table stop bolt (see Figure
64) and unthread it several turns.
Screw
Figure 64. Depth indicator set to "0".
4.
Adjust infeed table until it is level with outfeed
table.
5.
Using a screwdriver, precisely adjust scale
pointer to "0", then thread stop bolt into table
and secure with jam nut.
-46-
Table
Stop
Depth
Bolt
Indicator
Jam Nut
Adjusting Gibs
The function of the table gibs is to eliminate
excessive play in the table movement. The gibs
also control how easy it will be to move the tables
up and down.
Tools Needed
Open-End Wrench 12mm .................................. 1
Hex Wrench 4mm .............................................. 1
To adjust table gibs:
1.
Loosen two infeed table gib nuts on front of
jointer base (see Figure 65).
Figure 65. Infeed table gib controls.
2.
Oil table ways and outfeed leadscrew if
needed (see Page 38).
3.
Evenly tighten gib set screws a small amount,
then check table by moving it up and down.
Adjust set screws as needed until friction of
table movement is balanced between mini-
mal play and ease of movement.
Note: Tighter gibs reduce play but make it
harder to adjust tables.
4.
Repeat Steps 1–3 with outfeed table.
5.
Set outfeed table height as described in
Setting Outfeed Table Height on Page 44.
Model G0814/G0814X (Mfd. Since 04/22)
Qty
Gib Nut
Gib Set Screw
Advertisement
Table of Contents
